Content Source: 2019 Indian Rider’s Manual (9929709 R01) > Pre-Ride Inspections Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Engine Oil Level

With the semi-dry sump lubrication system, the engine oil level on the dipstick will fluctuate, depending on the motorcycle’s position and engine temperature when checked. To ensure a proper reading of the engine oil level, follow all inspection procedures closely.
WARNING
Operating with insufficient, deteriorated or contaminated engine oil will cause accelerated wear and may result in engine or transmission seizure, which could result in loss of control and serious injury or death. Check the oil level frequently. We recommended checking the oil each time you refuel.
The engine must be at normal operating temperature when checking the oil level.
NOTICE
Oil level will NOT be accurate if checked on a cold engine. DO NOT ADD oil to bring level to the FULL mark on a cold engine, as this can result in overfilling.
The oil fill cap/dipstick is located on the left side of the motorcycle . A special tool is provided in the tool kit to assist with dipstick removal. Always use the recommended oil. See Engine Oil Recommendation.
Image

Checking The Engine Oil Level

  1. Start the engine and allow it to run until it reaches normal operating temperature.
  2. Stop the engine and wait 1–2 minutes before checking the oil level.
    TIP
    If the oil level is not checked within 3 minutes, repeat steps 1–2.
  3. Position the motorcycle on level ground in the fully upright and centered position.
  4. Remove the dipstick and wipe it clean.
  5. Reinstall the dipstick until fully seated.
  6. Remove the dipstick and view the oil level.
  7. Add the recommended oil as needed to bring the level within the safe operating range (anywhere between the two marks on the dipstick with engine at operating temperature). If the oil level on the dipstick is anywhere in the safe range, do not add oil. Oil should be added only if the proper oil check procedure is followed AND the level is below the ADD mark.
  8. Do not overfill. Overfilling can result in loss of engine performance and an oil-saturated air filter. Use a suction device to remove excess oil if overfilled.
    TIP
    The approximate volume difference between the ADD and FULL marks on the dipstick is 32 oz. (.94 l).
    Image
    • ADD Mark
    • FULL Mark
  9. Repeat steps 1–7 to ensure the level is within the safe operating range.
  10. Reinstall the dipstick securely.

© Copyright Polaris Industries Inc. All rights reserved.