Content Source:
2019 Indian Rider’s Manual (9929709 R01) > Maintenance Chapter
| IMPORTANT |
|
The Owner's Manual for this vehicle contains
warnings, instructions and other information you must read and fully
understand
before safely riding or performing maintenance
on this vehicle.Always follow the warnings and instructions in Owner's
Manual.
Click the CONTENTS link above for the Table Of
Contents, or download a full PDF of the Owner Manual in the Owner
Support area
of Polaris.com
|
Headlight Lamp Replacement
| NOTE |
| For vehicles equipped with LED headlights, the headlight is not serviceable.
If the headlight becomes damaged or inoperable,
the entire headlight assembly
must be replaced. See your authorized INDIAN MOTORCYCLE dealer. |
Applies to: CHIEF MODELS/SPRINGFIELD
- Remove the six bolts
securing the front nacelle headlight shroud. Pull this piece forward
to access the headlight.
- Remove the sealing
boot. Press the looped end of the wire bulb retainer clip and swing
the end toward the center of the bulb
to release it from the latch tab.
- With the wire connector
attached, pull the bulb out. Disconnect the wire harness.
- Install the new bulb
and secure the retainer.
| TIP |
| Avoid touching a halogen lamp with bare fingers. Oil from your skin
leaves a residue, causing a hot spot that will shorten
the life of the
lamp. If a lamp is touched, clean it thoroughly with denatured alcohol. |
- Reinstall the sealing
boot. Make sure it seals tightly around the bulb base and lens to
prevent condensation.
- Reinstall the front
nacelle headlight shroud.
- Tighten the two (2)
top bolts.
- Tighten the four
(4) rear bolts.
| TORQUE |
| 84 in-lbs (9.5 Nm) |
