Content Source:
2020 Indian Scout Bobber / Bobber 20 Owner’s Manual (9929432 R03)
> Maintenance Chapter
| IMPORTANT |
|
The Owner's Manual for this vehicle contains
warnings, instructions and other information you must read and fully
understand
before safely riding or performing maintenance
on this vehicle.Always follow the warnings and instructions in Owner's
Manual.
Click the CONTENTS link above for the Table Of
Contents, or download a full PDF of the Owner Manual in the Owner
Support area
of Polaris.com
|
Rear Brake Fluid
Change the brake fluid
at the intervals recommended in the Periodic Maintenance Table section.
Always add brake fluid from
a new, unopened container. Always use the recommended
fluid. See
Brake
Fluid.
- Position the motorcycle
on level ground in the fully upright position.
- The rear brake fluid
reservoir is located near the rear brake pedal. View the reservoir
from the right side of the vehicle.
- Wipe the fluid container
and the area around the reservoir cover with a clean cloth.
- If the fluid level
is low, inspect brake pads as outlined on Brake
Pads. If pads are not worn beyond the service limit, inspect the
brake system for leaks.
- Remove the cover
and diaphragm. The fluid level should be above the minimum indicator
mark on the reservoir body
. Add brake fluid
as needed. Do not overfill.
- Reinstall the cover
and diaphragm. Tighten the cover screws.
| TORQUE: 13 in-lbs (1.5 Nm) |
- Wipe away any fluid
spills. Check for signs of brake fluid leaks around hoses, fittings,
reservoir, and brake calipers.
