Content Source: 2020 Indian Scout Bobber / Bobber 20 Owner’s Manual (9929432 R03) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Headlight Aim Inspection

On LOW beam, the horizontal cut-off of the light beam should be 4 in. (10 cm) lower than the center of the headlamp bulb and centered straight ahead at 32 ft. 10 in. (10 m).
  1. Verify that tire pressure is at specification. See the Tire Pressure section for details.
  2. Verify that rear suspension ride height (preload) is at specification. See the Rear Shock Preload (Ride Height) Inspection section for details.
  3. Position the motorcycle on a level surface with the headlight 32 ft. 10 in. (10 m) from a wall.
  4. With the operator and passenger (if applicable) on board, bring the motorcycle to the fully upright position.
  5. Start the engine and switch the headlamp to low beam. Observe the headlight aim on the wall.
  6. Make any necessary adjustments to headlight aim.
Image
NUMBER DESCRIPTION
4 in (10 cm) to top cut-off of beam
Measure distance = 32 ft 10 in (10.0 m)
Headlight Center

© Copyright Polaris Industries Inc. All rights reserved.