Content Source: 2019 Slingshot Owner’s Manual (9928978 REV 05) > Operation Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Using Cruise Control

The cruise control switches are located on the turn signal lever. Make sure you read this section and understand how to safely operate this feature before using the cruise control.
WARNING
Improper operation of cruise control could cause loss of control and result in serious injury or death. Follow all cruise operation procedures carefully. Never use cruise control when roads are wet or slippery. Do not use cruise control when driving in heavy or congested traffic.
NOTE
Cruise control functions will not be available until the brake has been applied firmly at least once after a restart of the vehicle.

Cruise Control Tips

  • Cruise control can be set in any gear.
  • Vehicle speed must be above 25 MPH (40 km/h).
  • Set speed will vary slightly in hilly terrain.
  • The cruise control will not resume a pre-set speed if the resulting acceleration or deceleration rate is too high or too low. For example, resuming a set speed from 30 MPH (48 km/h) while in 5th gear may cause cruise to disengage.
  • Cruise control will not engage if brake lights are not operating properly.
  • Cruise control will be disabled if there is an active stability or traction control event.
  • Cruise control will be disabled if there are multiple wheel speed sensor faults or a communication error with the electronic stability module.

Set Speed

  1. Move the cruise control ON/OFF/RES switch to ON to activate the cruise control.
    Position Function
    Left Reset (+)
    Center On
    Right Off
  2. Accelerate to the desired speed. Press and release the SET switch at the tip of the lever.Image

Cancel Cruise Control

To temporarily cancel the cruise control and allow use of the resume feature, perform one of the following:
  • depress the brake pedal or
  • depress the clutch pedal
To cancel the cruise control and erase the set speed from memory, move the ON/OFF/RES switch to OFF.

Resume Speed

  1. Disengage the cruise control by depressing the brake pedal or clutch pedal.
    NOTE
    If you depress the throttle pedal to accelerate, the cruise control will resume the previously set speed when the pedal is released.
  2. Move the ON/OFF/RES switch to RES to resume operation at the previously set speed.
    NOTE
    Moving the ON/OFF/RES switch to OFF will erase the set speed from memory and disengage the cruise control.

Increase Speed Setting

Move and release the ON/OFF/RES switch to RES to increase the set speed in approximately one MPH (1-2 km/h) increments. Move and hold the ON/OFF/RES switch in the RES position to accelerate to a new SET speed. The speed will reset when the switch is released or after a maximum acceleration of approximately 10 MPH (16 km/h), whichever comes first.

Reduce Speed Setting

Press and release the SET switch to decrease speed in approximately one MPH (1-2 km/h) increments. Press and hold the SET switch to decelerate to a new SET speed (resets when switch is released), or to the minimum cruise speed of 25 MPH (40 km/h).

© Copyright Polaris Industries Inc. All rights reserved.