Content Source: 2019 Slingshot Owner’s Manual (9928978 REV 05) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Transmission Fluid

This fluid level does not require routine inspection. If gear shifting seems irregular or if you suspect a fluid leak, inspect the fluid level.
Always change the transmission fluid at the intervals outlined in the Periodic Maintenance Chart section. Always use SLINGSHOT Transmission Fluid or another GL-3 rated transmission fluid. See the Recommended Service Products chapter for the part numbers of recommended service products.
The fill plug is located on the left side of the gearcase. The drain plug is located on the right side of the gearcase.

Fluid Level Check

  1. Elevate the vehicle using appropriate jack stands. Make sure the elevated vehicle is level.
  2. Remove the fill plug . If the fluid level is not within 5 mm of the bottom edge of the fill hole, add the recommended fluid to bring the level to the bottom edge of the fill hole.
  3. Reinstall the fill plug.
    TORQUE
    19-35 ft-lbs (26-48 Nm)
  4. See your dealer for service. A low fluid level indicates a fluid leak.Image

Fluid Change

  1. Elevate the vehicle using appropriate jack stands. Make sure the elevated vehicle is level.
  2. Remove the fill plug.
  3. Place a drain pan under the drain plug .Image
  4. Remove the drain plug. Allow the fluid to drain completely.
  5. Clean and reinstall the drain plug with a new o-ring. Torque to specification.
    TORQUE
    19-35 ft-lbs (26-48 Nm)
  6. Add the recommended fluid. Do not overfill. Maintain the fluid level at the bottom edge of the fill hole.
    FLUID CAPACITY
    2.75 qts (2.6 liters)
  7. Reinstall the fill plug with a new o-ring. Torque to specification.
    TORQUE
    19-35 ft-lbs (26-48 Nm)
  8. Check for leaks. Dispose of used fluid properly.

© Copyright Polaris Industries Inc. All rights reserved.