Content Source: 2019 Slingshot Owner’s Manual (9928978 REV 05) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Headlamp Bulb Replacement

When servicing a halogen lamp (bulb), avoid touching the lamp with bare fingers. Oil from your skin leaves a residue, causing a hot spot that will shorten the life of the lamp. If fingers do touch a lamp, clean it with denatured alcohol.

Outer Headlamps

  1. Pull the sealing boot away from the back of the bulbs and housing.
  2. Press the looped end of the wire bulb retainer clip and swing the end toward the center of the bulb to release it from the latch tab.
  3. With the wire connector attached, pull the bulb out.
  4. Disconnect the wire harness. Install the new bulb and secure the retainer.
  5. Reinstall the sealing boot. Make sure it seals tightly around the bulb base and lens to seal off from moisture.

Center Headlamps (if equipped)

  1. Disconnect the headlight wiring harness at the rear of the headlights.
  2. From the rear of the headlight, grasp the bulb housing and rotate it counter-clockwise to remove it.
  3. Install the new bulb and rotate it clockwise to secure it.
  4. Reconnect the wiring harness.

© Copyright Polaris Industries Inc. All rights reserved.