Content Source:
2019 Slingshot Owner’s Manual (9928978 REV 05) > Maintenance Chapter
IMPORTANT |
The Owner's Manual for this vehicle contains
warnings, instructions and other information you must read and fully
understand
before safely riding or performing maintenance
on this vehicle.Always follow the warnings and instructions in Owner's
Manual.
Click the CONTENTS link above for the Table Of
Contents, or download a full PDF of the Owner Manual in the Owner
Support area
of Polaris.com
|
Headlamp Aim Adjustment
(Canada)
- Verify that headlamp
aim inspection conditions are met. See Headlamp
Aim Inspection Conditions.
- Position the vehicle
on a level surface with the nose approximately 25 ft. (7.6 m) from
a wall .
- Move the ignition
switch to the ON position to turn the lights on. Place the headlamps
on low beam.
- Observe the headlight
beam display on the wall. The beam displays at two levels, higher
at the right side and lower at the
left side.
- Measure from the
floor to the lower beam display at the left side as illustrated. When
the beam is properly adjusted, this
measurement should be in the following range:
- 20-21.75” (51-55
cm) for base model
- 21-22.75” (53.3-57.8
cm) for SL model
- To adjust a headlight
beam, open the hood and turn the two upper headlamp screws simultaneously and equally.
- Clockwise adjustment raises the beam
- Counter-clockwise adjustment lowers the beam