Content Source: 2019 Slingshot Owner’s Manual (9928978 REV 05) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Display Screen

Image
WARNING
Driving while distracted can result in loss of vehicle control, crash, and injury. We strongly recommend that you use extreme caution when using any device that may take your focus off the road. Your primary responsible is the safe operating of your vehicle. We recommend against the use of any hand-held device while driving and encourage the use of voice-operated systems when possible. Make sure you are aware of all applicable local laws that may affect the use of electronic devices while driving.

Ride Command™ Buttons

Button Function
Image Rider Screen Button

Press the Rider Screen button to access the customizable split screen menu system, access to ride data, vehicle status, and vehicle information.

Image Navigation Button

Press the Navigation button to access Ride Command™ navigation features (if equipped), find directions, and look up addresses, gas stations, and other points of interest.

Image Bluetooth Button

Press the Bluetooth button to pair a phone or headset to the Ride Command™ display.

Image Power Button

Press the Display On/Off button to turn the Ride Command™ display on and off while motorcycle is in use.

Image Audio Button

Press the Audio Button to change the audio source, and set radio presets.

Image
Volume Decrease Button

Press the Volume Decrease Button to adjust the volume downward.

Image
Volume Increase Button

Press the Volume Increase Button to adjust the volume upward.

Ride Command™ Settings

The Settings Menu is where you can personalize your Navigation System. You can configure settings, such as Language, Speed Units, Time Formats, as well as audio and vehicle settings. The Settings Menu is composed of 4 categories that allow you to customize your screens; General, Time, Audio, and Vehicle.

General

From the General settings menu you can do the following:.
  • Change the Language
  • Set the Speed Units (MPH or KPH)
  • Set the Temperature Units (F or C)
  • Set the Volume Units (Gal or L)
  • Set the Pressure Units (PSI or Bar)
  • Update Software
  • Update Maps

Time

From the Time Settings you can do the following:
  • Set the Time Format (12 hour or 24 hour)
  • Enable GPS Time, which automatically sets the time to the time zone you are currently in
  • Set the time
  • Enable/Disable Daylight Saving Time

Audio

From the Audio Settings you can do the following:
  • Enable Automatic Volume Control
  • Set the Equalizer settings
  • Adjust the Fade and Balance
  • Clear AM/FM Presets
  • Set the Radio Tuner Region

Vehicle

From the Vehicle Settings you can do the following:
  • Oil Life/ Service Reset
  • Access Vehicle Diagnostics
  • View GPS Status
  • Override Automatic Power Down
NOTICE
More information about the Ride Command display can be found on the Polaris website: www.polaris.com/en-us/slingshot/ride-command.

Back-Up Camera (if equipped)

Some SLINGSHOT vehicles are equipped with an accessory back-up camera. The back-up camera is not intended to replace standard driving practices of checking your surroundings before operating in reverse. Always check for pedestrians, vehicles and other obstacles before operating in reverse.
If your vehicle is equipped with a back-up camera, view the image on the display screen as needed while operating in reverse. See Reverse Operation. The camera and display screen automatically activate when the transmission is shifted to reverse gear.

© Copyright Polaris Industries Inc. All rights reserved.