Content Source: 2019 Slingshot Owner’s Manual (9928978 REV 05) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Center Headlamp Aim Adjustment (USA)

  1. Verify that headlamp aim inspection conditions are met.
  2. Position the vehicle on a level surface with the nose approximately 25 ft. (7.6 m) from a wall .Image
  3. Move the ignition switch to the ON position to turn the lights on. Place the headlamps on low beam.
  4. Observe the headlight beam display on the wall. The beam displays at two levels, higher at the right side and lower at the left side.
  5. Measure from the floor to the lower beam display at the left side as illustrated. When the beam is properly adjusted, this measurement should be in the following range:
    • 19-20.75” (48-53 cm) for base model
    • 20-21.75” (51-55 cm) for SL model
  6. To adjust a headlight beam, open the hood and turn the two upper headlamp adjustment screws simultaneously and equally.Image
    • Clockwise adjustment lowers the beam
    • Counter-clockwise adjustment raises the beam

© Copyright Polaris Industries Inc. All rights reserved.