Content Source: 2019 Slingshot Owner’s Manual (9928978 REV 05) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Brake System Inspection (SLR Only)

  1. Inspect all brake hoses and connections for dampness or stains from leaking or dried fluid. Tighten any leaking connections and replace components as necessary. See the SLINGSHOT Service Manual or your authorized dealer.
  2. Check the brake pedal for excessive travel or a spongy feel.
  3. Inspect the rotor to ensure tightness to hub.
  4. Check the brake pads for wear, damage and looseness.
  5. Inspect brake discs for nicks, scratches, cracks or other damage. Clean any grease using an approved brake cleaner or alcohol.
    WARNING
    Do not apply WD-40 or any petroleum product to brake discs. These types of products are flammable and may also reduce the friction between the brake pad and caliper.
  6. Inspect the brake disc spline and pad wear surface for excessive wear. Change pads when worn to 3/50'' (1.5 mm).
  7. Inspect the thickness of each brake disc at four or more locations around the disc. If any disc is worn to the minimum thickness at the thinnest point, or if a disc is damaged, see your dealer for replacement.
  8. The SLR model comes with a 2–piece rotor. Check that the rotor is tightened adequately to the hub.

Image
3/50'' (1.5 mm)

Image
Minimum Thickness
Front: 19 mm / Rear: 19 mm

© Copyright Polaris Industries Inc. All rights reserved.